Statement necklace

Find your project

Statement necklace

Cut a long length of cord and start to thread on the bead has been threaded to hold it in place. Keep threading on the beads until the desired length has been achieved. Then, add the necklet ends, jump rings and toggle clasp.

Roll out the PMC and form it over a bead to create a decorative bead cap, allow for the clay to shrink a little. Once it has completely dried out, fire the clay using the Dremel VersaFlame.

Use the Dremel Engraver and Diamond Engraving Tip 9929 to add a scroll design over the silver bead cap. Polish the bead cap using the DREMEL 7700 together with the Dremel SpeedClic Mandrel SC432S. By applying some Dremel Polishing Compound 421 during the process, you will achieve the best finish. Thread the bead onto the head pin, then the bead cap over the bead. Bend the end of the head pin into a loop with the pliers and attach it to the center of the necklace.

  • Dremel 9929 Diamond Engraving Point

    9929 Diamond Engraving Point Show details
  • Dremel EZ402 EZ Lock Mandrel (Silver)

    SC402 Speed Clic Mandrel Show details
  • Dremel 423E EZ Lock™ Polishing Cloth Bit 25.4mm

    423E EZ Lock Cloth Polishing Wheel Show details
  • Length of cord
  • Glass beads
  • Necklet ends
  • Jump rings
  • Toggle clasp
  • Precious metal clay (PMC)
  • Head pin
  • Pair of pliers