Wooden bowl filigree patterned rim

Find your project

WOODEN BOWL WITH FILIGREE PATTERNED RIM

Measure the diameter of your dish and divide it into equal squares. Cut squares of paper and stick onto the bowl’s rim with masking tape to mark off your square. Using the Dremel 7700 and engraving cutter 107 make a random dot pattern.

Move the squares to mark up your next square. Decorate that square with wavy lines and dots using engraver cutters 111 and 106. Blow off the dust as before.

Move squares on again and decorate with lines.

Continue until the entire rim is decorated. Wipe the surface with a damp cloth.

  • Dremel 106 High Speed Steel Engraving Cutter 1.6mm

    106 Engraving Cutter Show details
  • Dremel 111 High Speed Steel Engraving Cutter 0.8mm

    111 Engraving Cutter Show details
  • Dremel 107 High Speed Steel Engraving Cutter 2.4mm

    107 Engraving Cutter Show details
  • Wooden dish
  • Damp cloth